Landscaping and backyard home improvement vendors

You provide the labor, and we provide all the supplies you need to make it happen. Don’t be scared. You can do it. Step-by-step installation instructions and free access to our phone and online installation support are available for those brave few. The installation of synthetic grass is not difficult, and it can typically be done over a weekend with a little help from a couple of friends. Email or call for more information or click here for instructions.

This manual outlines simple day-to-day care and those occasional times when spills or stains are a concern. The proper program of care will significantly enhance the aging, usefulness and aesthetics of your Lawn Arranger synthetic turf product.

GENERAL MAINTENANCE

In general, treat your Lawn Arranger synthetic turf as you would a grass lawn. Keep loose debris such as leaves and similar items off the lawn. This can be accomplished with a leaf blower, plastic grass rake, or push broom. Use care that the airflow from the blower, the rake, and the broom bristles are used above the top of the Lawn Arranger synthetic turf surface. Do not let the cleaning utensils penetrate deep into the turf pile, as this may displace the rubber infill.

Rain is your best cleanser as it gently cleanses the Lawn Arranger synthetic turf fibers of dust, pollen, and airborne pollutants. If the turf becomes dirty or dusty from use or weather between rains, simply rinse the lawn down with a hose spray. (Do not use a concentrated stream of water.) This will rinse the turf blades, and the residue will drain down through the drainage holes as the rain would.

Since Lawn Arranger synthetic turf is made of non-absorbent polyethylene fibers, the concerns for staining, and housing of odors and bacteria are very minimal. Remove and dispose of solid waste the same way you would on regular grass (scoop), and then the area should be rinsed with water. Areas where pets urinate should also be rinsed periodically to ensure that an odor does not build up in the ground area underneath the turf.

If an odor does develop in an area of constant urination, neutralize with mixture of white distilled vinegar in an equal amount of water, or use products found at your pet store. Spray thoroughly with water after application.

GENERAL STAIN REMOVAL

Lawn Arranger synthetic turf fibers are among the most stain resistant fibers available. Most stains are moisture borne and Lawn Arranger synthetic turf is made of non-absorbent fibers. Hence, most “stains” that get on your synthetic turf are residues and not true “stains”. Most of these residues can be rinsed off, or removed with mild soap and water. Promptness is the first rule as it is much easier to clean up a fresh spill before it has time to dry and harden. For more persistent stains, please see the following page.

Most "stains" can be classified as "water borne" stains. These stains are best removed using a warm, mild solution of granular household detergent (non abrasive).

Acid	Coffee	Glue	Ketchup
Alcohol	Cola	Ice Cream	Tea
Fruit Juice	Dye	Latex Paint	Urine

1. Brush the residue with a stiff fiber brush.
2. Scrub the area with soap and water.
3. Rinse the area thoroughly with clear water to remove all traces of soap.

A three percent (3%) solution of ammonia in water may be used in lieu of household detergent for more stubborn residues or stains.

Crayon, furniture stain, lipstick, metal polish, cooking oil, rubber cleat marks, shoe polish, suntan oil, ballpoint ink	Sponge with perchloroethylene (dry cleaning solution). Blot with absorbent towels.
Oil paints	Blot immediately. Sponge with turpentine or paint remover (apply sparingly). Blot with detergent and water. Re-sponge with cold water to remove detergent. Scrape excess. Sponge with perchloroethylene (dry clean solvent). Repeat steps as necessary.
Nail Polish	Sponge with acetone
Paraffin Wax	Scrape excess. Sponge with perchloroethylene.
Tar and Asphalt	Scrape excess. Sponge with perchloroethylene.

Spray with Freon and scrape to remove residue (available in aerosol packs from carpet cleaning suppliers--or use dry ice).

Use a one- percent solution of hydrogen peroxide in water. Sponge on. Flush thoroughly with water after application.